Make your own - Build a Zapper
Schematic for Zapper
Diagram for Zapper
Drawing for Zapper
First, what you need to know is that the zapper is simply a device designed to provide electrical pulses to your body in order to kill bacteria, protozoa, fungi, virus, and other parasitic organisms that feed off of your body.
With this in mind, it is easy to make a very cheap device that will provide electrical pulses to your body by providing a little of your own effort. You can actually kill some of the simpler microbes such as cold and flu virus by simply taping on the terminals of a 9 volt battery.
Yes, that is correct, just place a finger of one hand, either left or right, on the negative terminal of the battery. Then using one finger of the other hand, tap on the positive terminal repetitively for 7 minutes, stop and rest for 20 minutes, swap terminals so that the finger that was staying on the negative terminal is now doing the taping and the finger from the other hand is staying steady on the negative terminal. Tap for 7 minutes, then rest for another 20 minutes. After resting, swap terminals and tap for another 7 minutes. If you feel like doing more, rest another 20 minutes and then do it again.
This is very safe, with a couple of exceptions. Zapping is definitely not recommended for anyone who has a pacemaker or a personal defibrillator because, any electrical pulse can set these of and create a dangerous suituation.
Tweet
Buy ParaZapper™ with the latest and best technology updates from huldaclarkparazapper.com
Zapper by ParaZapper produces true squarewave
and positive offset under load.
Do not do this if you are pregnant or might be so, only because the effects of the zapper on an embryo are not known.
To improve your zapper, buy a 9 volt battery strap from Radio Shack or an electronics supply store along with 2 pieces of copper circuit board material ( 2 inches by 2 inches to 4 inches by 4 inches will do ). Solder each wire end to one of the circuit board sections, connect to the battery ( do not allow the boards to touch). Place a paper towel that has been soaked in salt water on each of the boards to keep the copper off of your skin. Do not allow the wet paper towels to touch or it will short out the signal. Place the palm of the hand or the wrist on the one with the black wire and tap the one with the red wire. The larger contact will produce a stronger signal.
Here is a testimonial It sounds too cheap, and simple to work, but I had really good luck killing Ascaris in the liver from tapping just on the 9 volt battery. from: https://curezone.org/forums/fm.asp?i=1438317#i
I am sure that after a while of taping on the battery, you will want to upgrade to a better unit.
When you are ready for quality and reliability, please consider a ParaZapper.
To improve your zapper, buy a 9 volt battery strap from Radio Shack or an electronics supply store along with 2 pieces of copper circuit board material. Solder each wire end to one of the circuit board sections, connect to the battery ( do not allow the boards to touch). Place a paper towel that has been soaked in salt water on each of the boards to keep the copper off of your skin. Do not allow the wet paper towels to touch or it will short out the signal. Place the palm of the hand or the wrist on the one with the black wire and tap the one with the red wire. The larger contact will produce a stronger signal.
Schematic for the ParaZapper:
An improved Hulda Clark Zapper
